Builder Compatibility

Brand Ecosystems

FanatecSemi-closed MOZASemi-closed SimucubeSemi-closed Logitech GSemi-closed ThrustmasterSemi-closed AsetekSemi-closed Sim-LabOpen Trak RacerOpen Next Level RacingOpen

All Categories

Wheelbases Wheel Rims Pedals Cockpits Seats Seat Brackets / Sliders Monitor Stands Shifters Handbrakes Accessories

Entry Tier

Under $1,000 $1,000 - $2,000

Mid Tier

$2,000 - $3,000 $3,000 - $5,000

High-End Tier

Premium ($5,000+)

Builder Compatibility

Brand Ecosystems

Fanatec MOZA Simucube Logitech G Thrustmaster Asetek Sim-Lab Trak Racer Next Level Racing

All Categories

Wheelbases Wheel Rims Pedals Cockpits Seats Seat Brackets / Sliders Monitor Stands Shifters Handbrakes Accessories

Entry Tier

Under $1,000 $1,000 - $2,000

Mid Tier

$2,000 - $3,000 $3,000 - $5,000

High-End Tier

Premium ($5,000+)

Loading PaddockForge workspace...

PADDOCKFORGE

PaddockForge is a decision-support platform for planning a compatible sim racing setup. Use the sim rig builder and compatibility checker to compare wheelbases, pedals, cockpits, and related hardware by budget, platform, and space.

Affiliate disclosure: some outbound merchant links may become affiliate links in production. Product recommendations are based on compatibility logic and planning utility.

Categories

Wheelbases Wheel Rims Pedals Cockpits Seats Monitor Stands Shifters Handbrakes

Guides

Beginner Setup Small-Space Setup Upgrade Priority Triple vs Ultrawide vs VR

Brands

Fanatec MOZA Logitech G Sim-Lab Next Level Racing

Site

About Contact Printable Accessories Affiliate Disclosure Privacy Terms

Printable Accessories

Printable Monitor Bezel Spacer

A printable spacer concept for monitor alignment and bezel consistency in triple-screen sim racing layouts.

Cockpit Category Wheel Stand Category Open Rig Builder

Compatible With

Triple monitor stand builds using 27 to 32 inch displays.
Cockpit classes with independent or integrated monitor stands.
Users prioritizing visual seam consistency in side-panel transitions.

Required Hardware

M4 or M5 fasteners based on stand mount pattern.
Washers and lock nuts for vibration resistance.
Basic hex key set and caliper for print tolerance checks.

Print Recommendations

Material: PETG for heat resistance and dimensional stability.
Layer height: 0.2mm for fitment reliability.
Infill: 35% to 45% for balance between rigidity and print time.

Install Notes

Dry-fit on one monitor joint before printing full sets.
Re-check monitor angle after installing spacers.
Route display cables after final alignment to avoid stress.

FAQ

Can this be used with any monitor stand?

Fitment depends on your bracket geometry and fastener spacing. Verify dimensions against your stand before printing multiple parts.

Is PLA sufficient for this part?

PLA can work in cooler rooms, but PETG is generally safer for parts near warm displays or enclosed racing spaces.